Tilt trim probs
Submitted by shane78 on Wed, 2022-12-14 16:40
Hi guys anyone know of someone nor to have a look at a problematic tilt trim, keep blowing fuses, I believe this is a problem I inherited when I bought the boat as its has an aftermarket inline fuse in the power line would only rarely blow a fuse but now just blows a fuse when I press the button, any help greatly appreciated
Faulkner Family
Posts: 18029
Date Joined: 11/03/08
Have you checked all the
Have you checked all the wiring. There may be an exposed wire shorting out on another wire along the line
RUSS and SANDY. A family that fishes together stays together
Bodgy 79
Posts: 287
Date Joined: 04/08/22
Yep check the back of
Yep check the back of switch,any wires rubbed through or squashed.you want good clean tight connections also and apart from that I'd say the motor would be rooted.Brocken or loose windings. What type of outboard?
little johnny
Posts: 5360
Date Joined: 04/12/11
My yammy replaced
Back and front .4 times . Switches are crap
shane78
Posts: 79
Date Joined: 10/12/14
Thanks guys, got it going, I
Thanks guys, got it going, I believe the seals in the pump or motor may be gone and letting water in and causing corrosion, after a few hit with the trusty hammer trying to remove the motor I managed to free it up and it works fine again, so hopefully I can put a kit through it and be done with it.