There was somebody a while ago, I was contemplating to a design moulds for him, but it basically fell through because you can get moulds cheaper from US than buying material here (on those lines). So unless you have a lot of money to spend and have some super special design of your plastic in mind, I would suggest to buy the moulds. I think the same company sells the plastic as well, you just need to look it up, I don’t remember the company’s name.

Makes his own plastics and I have caught fish on them.

Send him a PM and I'm sure he will help you answer some questions

i make my own and they go off

   jeff

 Cheers Guys,

Just came accross this so should be able to get sorted.

http://www.u-make-emsoftplastics.com.au/

Cheers Rusty

yep peter on the above link is very helpfull

has everythig u need from the rubber to make the moulds to the casting "plastic"

I have just got into it....... pretty simple with a bit of trial and error. Making the plastics starts to get almost addictive pretty quickly.

Brought the plastic and some colours from u-make-em (link above). I have actually found that using some crayon shavings as being the best colour solution as a beginner

I have just posted up a couple of pics of some fish I snagged on my own creations last weeked

Steve