boat polish
Submitted by streaker boy on Sun, 2010-01-10 15:06
im after some cutting polish for my boat gone a bit yellow brown stain from where it sits in the water whats the best stuff out on the market for this job
HuggyB
Posts: 2515
Date Joined: 03/08/08
Off the top of my head
Meguiars, Mothers and 3M do "marine spceific" polishes, cutting compounds, waxes etc. But really, any cut and polish will do the trick - gelcoats and paint/clearcoat are not too dissimilar.
I'd follow up with a wax to protect all your hard work.
The Terrorist - coming to a fishing spot near you.........
Blank Cheque
Posts: 221
Date Joined: 28/03/09
3M Finess it
Great stuff i was asked if i had repainted my boat after using it.
Garry
Its a little late to head home early
Faulkner Family
Posts: 18029
Date Joined: 11/03/08
use proper stuff, and make
use proper stuff, and make sure its not like the orange stuff, it will discolour the boat especially the rubbers
RUSS and SANDY. A family that fishes together stays together
southcity104
Posts: 1659
Date Joined: 27/01/09
Streaker id recomend
Begin with a liqht acid wash to remove stains (peter G's Clean a hull) works well
Then follow up with a wax restorer like (malco rejuvenator) Much cheaper than 3m finnese-it products and works as well.
Use a lambs wool buff and some technique
If this doesnt bring it up then you may have to apply heavier compound polish.
let us know how you go.
"Its a life style job"
streaker boy
Posts: 527
Date Joined: 23/05/09
thanx guys and yeah i know
thanx guys and yeah i know not 2 use those orange 1's
i got some of this boatcare fibreglass polish extra cut in the morning and started on it but i dont think its 100%
grayzeee
Posts: 2283
Date Joined: 09/07/09
i got told to avoid anything
i got told to avoid anything with canuba in it.
discolours the glass or something
If I spent half as long fishing , as I do reading this bloody forum , I'd be twice the fisherman I am.
shammy
Posts: 231
Date Joined: 03/07/09
polish
After I did the cut and polish to get rid of all the old rubbish, I used Maguires and it worked a treat.
That's my choice.
"Life wasn't meant to be a spectator sport"
Decella
Posts: 401
Date Joined: 01/02/09
IMAR Yacht polish
You buy this at Wilson boating in freo you can get there off Catalano drive they are on the street inside Freo Boat club. All the pro boat detailers use it.
pale ale
Posts: 1755
Date Joined: 02/01/10
Any further reccommendations
Any further reccommendations on a boat polish. I wanna get the missus to polish my vessel
Are these products one application, or are there 2-3 steps?
Brody
Posts: 1025
Date Joined: 06/02/07
I'd suggest copious amount
I'd suggest copious amount of alcohol if you want to lure the missus into polishing your vessel.
hekser
Posts: 572
Date Joined: 31/03/10
LOL
gold.
pale ale
Posts: 1755
Date Joined: 02/01/10
Ha ha, here I am at work,
Ha ha, here I am at work, and she is home drinking my beer
will see how it goes
nico
Posts: 226
Date Joined: 17/08/10
polishing
Depending on the condition of gel / paint and how fussy you are you might consider wet n dry from 800g to 1500 then cut then polish the key is to wax though this is the sealer.Most peopole finish on a polish and say job done not so wax will gloss it more and help to bead water for a longer duration. This process of waxing must be applied every 3 months to protect the exterior all the polishes mentioned above will work and the tip on peter g hull wash is gold wear gloves!!.Never wash yo r boat in cheap detergent as it will strip the wax and polish straight away a lot of hard work for nothing the exterior finish is just as important as that on a car and for resale it is wise to keep it maintained good luck.
In Mocean
Brody
Posts: 1025
Date Joined: 06/02/07
Good luck mate.
Good luck mate.